PDA

View Full Version : Verse proximity in the GSE



mbixby@tcmissions.org
09-18-2008, 08:48 PM
Is there anyway to use verse proximity in the GSE? When I do the following search (imported into GSE from the command line): ('eij o *@vn*).;3('wste *@vn*), I get the following message.


"---------------------------
Can't run query
---------------------------
Verse proximity (in the merge boxes) can't be
used in a query using ordering or agreement.
To mix ordering and agreement with proximity conditions
Use WORD proximity (specified in ordering boxes) instead.

You may need to split your query into sub-queries.
The GSE tutorials give an example of this.
---------------------------
OK
---------------------------


I can run this search from the command line, but I have other searches I would like to do which I can't run from the command line (or at least don't think I can).

Any ideas?
file:///C:/DOCUME%7E1/mbixby/LOCALS%7E1/Temp/moz-screenshot.jpgfile:///C:/DOCUME%7E1/mbixby/LOCALS%7E1/Temp/moz-screenshot-1.jpg

Glenn Weaver
09-19-2008, 09:53 AM
Hi mbixby,

The message box gives the answer: "You may need to split your query into subqueries."

The attached query file has the upper merge box set to 3 verses. The lower two merge boxes are set to be subqueries. I typed your search on the command line, then opened the GSE. Then I checked the "Make subquery" option in the two lower merge boxes.

There is a requirement to turn off the hit highlighting. When you run the search, a message box alerts you to that and offs to turn off the hit highlighting.

Hope this helps.

mbixby@tcmissions.org
09-19-2008, 01:59 PM
Aha, that's the key. Thanks.

Matthew